基于金线填充的双芯光子晶体光纤偏振分束器

提出了一种基于金线填充的双芯光子晶体光纤超短偏振分束器,并进行了有限元分析.金线表面激发的表面等离子激元与双芯光子晶体光纤纤芯模之间的强烈耦合,导致更短的偏振分束器长度和更大的工作带宽.与同类的偏振分束器相比,所提出的偏振分柬器能同时实现较短的长度和较高的消光比.数值结果表明,长度为0.263 mm的偏振分束器,在波长1.55 μm处消光比达-70 dB,-20 dB消光比带宽为124 nm.     

自由旋涡气动窗口全流场的数值模拟

建立自由旋涡气动窗口全流场仿真模型,对大密封压比气动窗口的全流场展开数值研究,得到自由旋涡气动窗口的流场结构,发现大密封压比气动窗口形成的自由旋涡射流在光束输出通道内无明显的波系结构.根据模拟结果对自由旋涡气动窗口的性能进行优化,对自由旋涡喷管上壁面型线进行二次粘性修正.优化自由旋涡射流场后,激光器输出光束通道内压力分布稳定上升;增加扩压器外端壁吹气1.19MPa、内端壁吹气1.68MPa时,自由旋涡射流总能提高,气动窗口密封压力从37.5torr降低至6torr.该研究结果对自由旋涡气动窗口技术的发展具有参考意义.     

激光主动干涉条纹间距识别光学目标口径

利用物理光学相关知识及Collins衍射积分公式和硬边光阑的复高斯函数分解法,推导得到目标处干涉图样条纹间距与光学目标反射光时间分布关系的解析表达式.从原理分析、仿真计算和实验研究等方面研究了干涉场的条纹间距、光学目标口径参数和反射光时间分布包络的峰峰数、峰峰间距和峰峰比之间定量关系.结果表明,当条纹间距的大小约为目标的口径尺寸时,反射光时间分布包络的峰峰数由单峰向多峰过渡,峰峰间距和峰峰比曲线会出现极大值,根据这一变化规律可以估测出光学目标的口径参数,其估测精度受条纹间距可调节范围的影响.     

Use of stable carbon isotope ratios to determine the source of cypermethrin in so-called natural plant extract formulations used for organic farming

Some natural plant extract formulations (NPEFs, also referred to as essential oils) used in organic farming have been shown to contain synthetic pesticides. We obtained samples of four NPEFs (Muso, Hekiro, Kensogen-Ten, and Nurse Green) that were contaminated with the synthetic pyrethroid cypermethrin, and we used gas chromatography coupled with combustion, cryofocusing, and isotope ratio mass spectrometry to determine the stable carbon isotope ratios (δ¹³C) for the cypermethrin in the four NPEF samples, as well as in ten cypermethrin reagents and two commercial pesticide formulations (Agrothrin emulsion and Agrothrin water-dispersible powder). Our goal was to identify the source of the cypermethrin in the NPEFs. Cryofocusing markedly sharpened the cypermethrin peak and thus improved the accuracy and precision of the determined δ¹³C values. The δ¹³C values (±?SD) of the 16 cypermethrin samples ranged from ?28.3?±?0.2 to ?24.5?±?0.2?‰. Surprisingly, the four NPEFs showed similar δ¹³C values (?26.8 to ?27.3?‰), suggesting that the cypermethrin in all the samples came from the same source (either the same chemical reaction or the same primary material). This possibility was supported by previously published results. In addition, the δ¹³C values of the two commercial pesticides were similar to the values for the NPEFs, suggesting that the commercial pesticides had been diluted and sold as NPEFs.     

Evaluation of the performance of high temperature conversion reactors for compound-specific oxygen stable isotope analysis

In this study conversion conditions for oxygen gas chromatography high temperature conversion (HTC) isotope ratio mass spectrometry (IRMS) are characterised using qualitative mass spectrometry (IonTrap). It is shown that physical and chemical properties of a given reactor design impact HTC and thus the ability to accurately measure oxygen isotope ratios. Commercially available and custom-built tube-in-tube reactors were used to elucidate (i) by-product formation (carbon dioxide, water, small organic molecules), (ii) 2nd sources of oxygen (leakage, metal oxides, ceramic material), and (iii) required reactor conditions (conditioning, reduction, stability). The suitability of the available HTC approach for compound-specific isotope analysis of oxygen in volatile organic molecules like methyl tert-butyl ether is assessed. Main problems impeding accurate analysis are non-quantitative HTC and significant carbon dioxide by-product formation. An evaluation strategy combining mass spectrometric analysis of HTC products and IRMS ¹⁸O/¹⁶O monitoring for future method development is proposed.     

光谱特征提取对近似矿物光谱差异性影响分析

矿物光谱特征是基于光学遥感数据对矿物进行种类识别及定量反演的理论基础,光谱特征提取是高光谱数据常用的技术手段,但在多光谱数据中较少涉及。近似矿物识别是矿物光谱分类应用中的难点,目前还缺少有效指标来指示近似矿物类别光谱的差异性。光谱特征提取有望提高矿物分类精度,但该处理对近似矿物光谱差异性的影响还缺少相关研究。本文从矿物光谱差异性的原理出发,通过类间和类内光谱角的比值体现不同类别群体差异,并引入样本量因素,提出了类别可分比作为近似矿物光谱差异性的指标。以明矾石和高岭石两种近似矿物为例,对USGS光谱库光谱及Hyperion,ASTER,OLI等传感器的模拟数据进行光谱特征提取处理,通过对比处理前后矿物光谱差异性的变化,分析光谱特征提取对近似矿物光谱差异性的影响。实验结果表明,有效的光谱特征提取可以显著提高近似矿物光谱差异性,并且光谱分辨率越高,近似矿物光谱差异性越大。此外,光谱分辨率及中心波长设置对于包络线去除结果有很大影响,多光谱数据吸收特征提取效果有待进一步提高。该研究为今后近似矿物光谱识别精度的提高奠定了基础,也为未来新型遥感找矿传感器参数设置提供了参考。     

单脉冲和再加热正交双脉冲激光诱导击穿光谱对比研究

为了提高激光诱导击穿光谱技术(LIBS)的检测灵敏度和辐射光谱特性,采用再加热正交双脉冲结构对样品中的4种元素Fe,Pb,Ca和Mg以及含有不同浓度重金属元素Cr的土壤样品进行分析。研究了4条特征谱线FeⅠ：404.581 nm,PbⅠ：405.78 nm,CaⅠ：422.67 nm和MgⅠ：518.361 nm的光谱强度和信背比随两激光脉冲之间时间间隔的变化关系,获得了两激光脉冲之间最佳的时间间隔为1.0 μs。在单脉冲和双脉冲条件下,得到了4条特征谱线FeⅠ：404.581 nm,PbⅠ：405.78 nm,CaⅠ：422.67 nm和MgⅠ：518.361 nm光谱强度的增强倍数分别为2.23,2.31,2.42和2.10;分析了特征谱线FeⅠ：404.581 nm和CaⅠ：422.67 nm谱线强度随时间的演化特性以及4条特征谱线信背比随光谱采集延时的变化关系,双脉冲能有效延长光谱强度的衰减时间以及提高特征谱线的信背比;比较分析了等离子体温度和电子密度随时间的演化特性,在双脉冲条件下,等离子体温度最大升高了730 K,电子密度最大增加了1.8×1016 cm-3。单脉冲和双脉冲条件下获得重金属元素Cr的检测限分别为38和20 μg·g-1,再加热正交双脉冲技术使元素检测限下降近2倍。以上结果表明：再加热正交双脉冲能有效地提升LIBS技术的检测灵敏度和光谱特性,为进一步降低元素的检测限提供了有效的方法。     

Br_2分子在360—610 nm的光解离动力学研究

利用包含转动自由度在内的含时薛定谔方程研究了Br_2分子在波长范围为360—610 nm的光解离动力学.通过计算得到了Br_2分子在四个特征波长处的切片解离影像,并经过分析得到了与切片解离影像相对应的动能分布;计算了Br_2分子在波长范围为360—610 nm内总的动能分布,以及从A,B和C三个电子态解离的碎片各自所对应的动能分布;计算了A,B和C三个电子态各自的解离概率以及碎片产物的分支比Γ(Br~*/(Br+Br~*))随波长的变化.     

光学元件狭缝柔性调节机构的设计与分析

设计了一种狭缝柔性结构的光学元件调节机构,使光学元件在具备较高调节精度的同时,保持较高的导向精度。采用弹性力学应力函数法分析了狭缝柔性结构的刚度,以径向刚度与轴向刚度的比值为目标函数,对狭缝柔性结构尺寸参数进行了优化,在不超过柔性结构材料屈服应力等约束条件下,刚度比最优值达到1 573.6,较大的刚度比值可以减小调节机构的耦合位移,从而提高机构的导向精度。该结构加工装配方便,可实现三自由度(θx-θy-Z)调节。对优化后的柔性结构进行仿真分析,结果表明:径向刚度与轴向刚度比值的仿真值为1 660.4,解析值与仿真值误差为5.23%,证明了刚度分析方法的有效性。优化后的结构,轴向调节行程为2.09 mm,绕x轴偏转角度调节行程为±16.6 mrad,绕y轴偏转角度调节行程可达到±14.4 mrad,满足光学元件调节的大行程要求。     

Comparison of theoretical and experimental results for band-gap-graded CZTSSe solar cell

The simulation of CZTSSe solar cells is presented in this paper. The simulation results are in reasonable agreement with the experimental data, indicating the reliability of simulation results. New structure is proposed to increase the functionality of the cell. Improved functional performances are achieved by inserting a P-Silicon (P-Si) layer as back surface field. Simulation results suggest that by inserting this P-Si layer, efficiency of the CZTSSe solar cell increases from 12.6% to 16.59%, which is a significant improvement. For the champion cell J_SC = 36.27 mA/cm², V_OC = 0.625 V and FF = 73.11% has been achieved.